Alloy 20 Burn-In Process

1. After mounting the heat seal band in your machinery, turn on the system and perform an AUTOCAL
   
2. ​At the completion of AUTOCAL the Actual Temperature should represent the ambient temperature
   
3. ​To Burn-In the band, set the Sealing Temperature to 40°-50°C higher than your target sealing temperature
   
4. ​Without closing the jaw bars, initiate the heat for 20 seconds
   
5. ​After cooling, the controller will display an Actual Temperature value less than ambient
   
6. ​Repeat the AUTOCAL function and Burn-In procedure
   
7. ​The band is properly Burned-In when the controller displays an actual temperature equal to ambient temperature after the band cools down
   
8. ​Burn-In is now complete
   

​NOTE: Do not exceed a Burn-In temperature of 275°C without the proper Jaw Bar build up required for high temperatures.​